By bonoss|2019-11-26T04:51:42+00:00September 23rd, 2019|BLA Series|
The minimum thickness of the BONOSS customized BLA structure wheel spacer must meet the requirements of safe driving and mechanical structure design. Generally speaking, we recommended to be above 25mm, if the thickness
By bonoss|2021-10-27T01:46:30+00:00September 23rd, 2019|BLA Series|
In general,this problem does not occur, but this will happen in some special customization service situations. We will provide the special short wheel bolts to you to solve this situation.
By bonoss|2019-09-23T02:48:05+00:00September 23rd, 2019|BLA Series|
In general, the BONOSS supplied bolts won't be higher than the spacer upper surface, but this will happen in some special customization service situations. In general, our professional team members will contact you
By bonoss|2019-11-26T04:52:06+00:00September 23rd, 2019|BLA Series|
Remove wheel bolts and wheel. Place BONOSS Spacer on axle of vehicle (where the wheel was attached) making sure that the spacer is fully seated and flush with the hub. Fasten BONOSS spacer
By bonoss|2019-11-26T04:53:59+00:00September 23rd, 2019|BLA Series, BLM Series|
The material of the BONOSS wheel spacer studs/Bolts are high-strength alloy steel, forged process, ISO898-1 grade 12.9(partially grade 10.9) standard performance, the surface Anti-Rust of the studs were tested by a neutral salt
By bonoss|2019-11-26T04:54:46+00:00September 23rd, 2019|BLA Series, BLM Series|
The matching nuts of BONOSS wheel spacer are used to fix the wheel spacer to the hub axle and to tighten with the originial studs. The material of the nuts are high-strength alloy
