After much study about fitment and measurement between thickness and material, you’ve finally selected a new set of 2023 Subaru Justy wheel spacers for your ride. Now all you have to do is put them on your vehicle. Installing 2023 Subaru Justy wheel spacers is a pretty easy job. The installation process normally can be finished within an hour. In the process, you have to remove the entire wheels to get the new 2023 Subaru Justy wheel spacers installed, then tighten them up, and you’re ready to roll.
Whether you are using bolt-on 2023 Subaru Justy wheel spacers or slip-on spacers, you need to tighten each lug nut correctly. It is always recommended to use a torque wrench at the final torquing step. Untightened lugs (the clamping force is not enough) or overtightened nuts (the stud has been stretched past its tensile strength limit, so the clamping force has gone away) will cause most wheel spacer failures. After 50 – 100 miles of driving, check and retorque hardware.
Are Lug Nuts of 2023 Subaru Justy Wheel Spacers Important?
Any time you work on 2023 Subaru Justy wheel spacers, you must be incredibly careful and make sure everything is retightened to the correct torque specification. The lug nuts are fasteners that are screwed on the wheel studs, securely holding the wheels and tires to the axle hub. For most Subaru vehicles, the lug nuts are among the most important parts for fastening the 2023 Subaru Justy wheel spacers. So, you need to take good care of them.
To provide a safe and firm wheel joint, BONOSS 2023 Subaru Justy wheel spacers are equipped with ISO grade 10 lug nuts. The minimum proof load of ISO grade 10 lug nuts is 1,100 MPa which far exceeds the standard grade 6. Besides, they are Dacromet-coating. This type of coating gives salt spray resistances exceeding 500 hours. A good quality rustproof coating is helpful the keep the lug nuts from corrosion-related failure. That is why BONOSS 2023 Subaru Justy wheel spacers are much better and safer.
Is It Hard to Remove 2023 Subaru Justy Wheel Spacers?
Removing 2023 Subaru Justy wheel spacers isn’t hard. However, if you use Loctite on the wheel spacers, things may be a little troublesome when you intend to remove the wheel spacers for routine maintenance. That is because the threadlocker will glue the studs and nuts together. It makes the removal process hard. But like any other adhesive, using a heat gun to melt it will be useful.
To make the removal process easier, BONOSS 2023 Subaru Justy wheel spacers come with disassembly grooves. The disassembly grooves refer to the small notches which are distributed on the corner of wheel spacers. Normally, a notch leaves a limited clearance between the brake rotor and the spacer. When removing BONOSS 2023 Subaru Justy wheel spacers, get a flat-head screwdriver and place it on one notch. Pound a hammer to the screwdriver at a 45-degree angle and they should come off pretty easily.
